What if children's amusement equipment is worn? , Industry news-SKP company

How should we deal with wear and tear? Below, SKP company amusement equipment for your introduction.     (1)Early wear period of amusement equipment  First of all, the new amusement equipment wears very quickly when it is first used, and with the running-in, the rough appearance will be smoothed. At this time, the speed of wear will be reduced, this time the run-in period is over. This period of time is called the period of early wear.     At this time, the operator will consciously use the slight wear during this period to create conditions for stable wear during normal operation. During this period, regarding the equipment that has not been run-in, the principles of load reduction, deceleration and reasonable operation should be abided by, smooth oil with lower viscosity should be added, and constant temperature should be kept as far as possible. In addition, in order to shorten the running-in period, appropriate leading technologies can be selected to use lubricating oil that meets the quality requirements to improve the utilization rate of equipment.     (2)Stable running-in period of amusement equipment  This period is during normal operation. After the amusement equipment is running in, the conflict surface is hardened and the wear is slow and stable. In the later period of this period, due to metal fatigue, the wear is relatively accelerated, but it still can work continuously. When approaching the fatigue limit of metal, the operator must carry out regular and compulsory repair on the equipment, to prevent major accidents caused by excessive wear and tear of equipment.     (3)During severe wear of amusement equipment  During this period, because the metal outer layer of the amusement equipment reached the fatigue limit at all, the conflict conditions were greatly changed ( For example, the temperature rises sharply, the surface metal arrangement is obviously changed, the microscopic shape is changed, the gap is increased, the smooth conditions are deteriorated, etc) , The wear speed of the equipment increases sharply, the mechanical efficiency decreases, the precision loses, abnormal noise and vibration occur, and the mechanical properties of the data are changed, eventually causing the parts to fail and must be repaired. At this time, if it is forced to operate normally or even under high load, major accidents will inevitably occur.     So, what is the correct way to find that children's amusement equipment is worn out?     1. Lubrication. If the wearing parts of the amusement equipment are lubricated, the friction between the parts can be reduced, and the wear can be reduced;     2. If there is an error in the installation position of children's amusement equipment, wear will also occur. Therefore, SKP company amusement equipment reminds operators that in order to reduce wear and tear, it is necessary to improve the accuracy of installation and check it frequently.     3. Finally, there is another point. Some dust can also easily cause wear and tear of children's amusement equipment, and some can also cause rust and cause greater problems. Therefore, it is also very important to keep the amusement equipment clean.