Children's inflatable castle fault damage solution, industry news-SKP company

1, open glue  First, apply glue evenly on the place where the children's inflatable castle toy is to be pasted and on the cloth, then air it for half a minute, stick the cloth sample to the pasting place, flatten it without warping, and paste it. 2, the toy was cut  1) The stroke is longer than 5cm and should be sewn with needle and thread, and then pasted with cloth strips or samples.   2) The scratch is less than 5cm and can be directly pasted. 3. The seam is opened.   First sew the opening with a needle and thread ,(Or disassemble from the bottom of the air cushion and sew it) , Can be pasted to handle the opening firmly, while considering the beauty 4, beautify the edge  Apply a proper amount of glue to the warped edge with a small brush, press flat and compact after a short stop, and stick firmly to 5. Degumming  Some easy-to-wear parts are easy to degumming after long-term use, and the cloth can be cut into different shapes and pasted at the degumming place. 6. Large air leakage  After the toy is used for a long time, due to the large seam of the pinhole in some parts, the air leakage is greatly increased. It can be considered to stick the cloth strip to the seam to reduce the air leakage. If the toy is too old, it should be considered to be scrapped, in case there is a problem in the operation. 7. Local abnormal bulge of air cushion  In general, the towel of the children's inflatable castle is torn from the air cushion. The bottom of the air cushion can be disassembled along the seam. The lacing is connected to the air cushion with a needle and thread, and then the cloth strip is pasted to protect the seam.