Safety standards for amusement equipment, industry news-SKP company

1. Safety Insurance measures the overall structure of the passenger part of the amusement facilities running in the air should be firm and reliable, and the important parts should be insured. The number of wire ropes or chains used for hanging passengers shall not be less than two. The connection with the seat part must be balanced when one is disconnected. For closed cockpit doors more than 1m from the ground, two locking devices or one locking device with safety that cannot be opened by passengers inside must be set. The stopper at the entrance and exit of the non-closed cockpit should also have a locking device with insurance. When the amusement facilities are in operation, the power supply is suddenly cut off or the equipment fails, which endangers the safety of passengers, automatic or manual emergency shutdown devices must be provided. After the failure of the amusement facilities during operation, there should be measures to guide the passengers. 2. Passenger safety binding device when the amusement facility is running, when the passenger is likely to be moved, collided or thrown out or slipped out of the ride, a passenger binding device must be provided. For dangerous amusement facilities, two sets of independent binding devices should be considered when necessary. Safety belts, safety pressure bars, retaining rods, etc. can be used. Binding device: it should be reliable and comfortable, and the parts in direct contact with passengers should have appropriate softness. The design of the binding device should prevent a certain part of the passenger from being pinched or crushed, and should be easy to adjust and operate. Safety Belt: it can be used alone on facilities with slight swing or slow lifting speed, no turning and no danger of being thrown out. Generally, auxiliary handles should be equipped when using safety belts. For facilities with intense sports, safety belts can be used as auxiliary binding devices. Safety pressure bar: when the operation of the amusement facilities may lead to the danger of the passengers being thrown out, the corresponding type of safety pressure bar must be set; The safety pressure Bar itself must have sufficient strength and locking force to ensure that tourists will not be thrown out or dropped, and will always be locked before the equipment stops running. 3. Safety requirements for safety fence and platform safety fence should be set in and out respectively, and guide fence should be set at the entrance. The platform should have anti-skid measures. The opening direction of the safety fence door should be consistent with the direction of the passenger (Except for special circumstances). In order to prevent injury to the hands of personnel when closing the door, the gap between the door frame and the upright post should be appropriate, or other protective measures should be taken. The entrance and exit of the passenger part should not be higher than 300 of the platform for the amusement facilities that take passengers up and down while running. The height of the entrance and exit of other amusement facilities from the platform should be convenient for up and down. 4. Other safety requirements amusement facilities should set eye-catching safety signs in necessary places and parts. Safety signs are divided into prohibited signs (Red), Warning signs (Yellow), Instruction mark (Blue), Prompt mark (Green)Four types. Where passengers can reach, exposed sharp edges, sharp corners, burrs and dangerous protrusions are not allowed. The containment surface of culverts through amusement facilities shall be made of materials that are not easy to fall off, and decorations shall be fixed firmly. The number of passengers must be marked, and overloading is strictly prohibited. Related links: inflatable battery car cover children's inflatable battery car robot pedal inflatable trampoline slide